front end shakes when braking put new brakes rotors pads drums brake lines bearings still shakes 1996 f 250 4x4 One or both of your new rotors probably have some run-out in them.Not entirely unusual ...
...250 7.3 front driver side brakes are locking up its either the caliper or the brake line remove the caliper and try to squeeze the piston in with a c clamp if its tight its bad also remove the brake ...
...brake pads? Jack up the front of the vehicle remove tires remove caliper,being careful not to break fluid line using a c clamp squeeze the caliper piston back into caliper install new pads in caliper ...
250 the front brakes will lock up randomly I replaced the front pads and it still does it. Can a vacum line from the booster assist cause this No, you probably have a defect somewhere in your ABS unit
250. Rear ABS. When the truck is not running, plenty of pedal and brakes function, but when truck is running, pedal goes to the floor. After replacing the master cylinder and getting the same results,
...250 van 1987, front brakes are locking up by themselves , not touching the pedal,, when moving until the van stops completely ,, not able to move because front wheel are locked or when braking a ...
250 brakes I have a Ford F250 with a 7.3L diesel. When I start the engine the front brakes lock up. When I shut the engine off and remove the vacume line and check valve the wheel will then turn free.
250. Labor is about 2-3 hours. $1200 sounds steep to me. I would ask for a line item estimate. Thanks for using FixYa. http://www.autozone.com/autozone/parts/2004-GMC-Envoy-2WD/Brake-Caliper-Front/_/N
...250. changed master cyl and booster. and rubber brake hoses. still spongy and nothing is leaking.brakes went from being good to spongy in one application.help. Check the rear wheel cylinders? Was ...
Question about Pontiac Grand Am
...250 abs brake light comes on and rear wheel locks up. replaced rear sensor. still have problem. unplugged rear sensor , abs light still comes on. unplugged unit where line comes from mastercylinder ...
1,283 questions posted
Usually answered in minutes!
1,771 Questions
1,538 Questions
1,504 Questions
1,435 Questions
1,208 Questions