...bad injectors? engine starts and stays running until the key is released to disengage the starter.I tried a new pcm box and it didn't help. Changed fuel filter, idle position sensor,map sensor, ...
...camshaft position sensor bb1 open or short circuit condition bb2 poor electrical connection bb3 weak battery condition' bb4 faulty cmp please any help at all I am not sure where in a Sentra, but in a ...
...bad Hi there:The camshaft sensor is located in the hood, beside the engine. However, it isn't always easy to find it. This is because the exact position of the camshaft sensor depends on the car ...
...well as for support. you can look up more specific info for your vehicle on e-how.com. just type in for example : signs of a bad cam sensor on what year vehicle, how to change the part on vehicle
camshaft position sensor overadvanced...etc). Sometimes and when the car is cold and I start it, there is noise coming from the engine side (something stalling like (crrr crack..)). After that the car
...bad news but the codes are as follows. P0017-Crankshaft Position - Camshaft Position Correlation Bank 1 Sensor 'B' Possible causes - Mechanical timing fault - Blocked oil passage - Low oil level - ...
Question about Pontiac Trans Sport
...camshaft and crankshaft sensor so be sure you replaced the correct one. The code its giving you is a dead sign of no start and a bad sensor. Make sure its electrical connector is hooked up tight and ...
Question about Dodge Cars & Trucks
bad and needs to be replaced i am finding oil on the drivers side on the have replaced plugs looked clean in good working order where do i go from here and what should i do if a new cat on the exhaust
...bad. However, with new PCM, engine does start. My question - How is a failure of the PCM validated, as opposed to replacement that might have simply allowed whatever did fail to reset. Mechanic would ...
something in the wiring inside the sensor goes bad. Not usually any signs, they just seem to go out randomly. Not sure how hard they are on the hyundai's, but it should be somewhere on the valve cover
128 questions posted
Usually answered in minutes!
243 Questions
125 Questions
113 Questions
76 Questions
45 Questions