...BRAKE LIGHT SWITCH FUSE AND BRAKE SHIFT INTERLOCK SOLENOID FUSE.IF FUSES ARE GOOD.REPLACE BRAKE LIGHT SWITCH FIRST.BECAUSE BOTH COULD BE PROBLEM.BUT MOST OF THE TIME ITS THE BRAKE LIGHT SWITCH.THAT ...
Question about Pontiac Bonneville
brake light switch to turnsignal switch, to lights. Did you take a test light and test to see where you were getting power and not getting power. This is your first step. Sometimes people put to large
...BRAKE LIGHT SWITCH OR A BAD TURN SIGNAL SWITCH. THE BRAKE LIGHT CIRCUIT GOES UP THROUGH THE TURN SIGNAL SWITCH & THEN TO THE BRAKE LIGHTS. FIRST OF ALL IS THE BRAKE LIGHT SWITCH GOOD ? THE ORANGE ...
...distance to brake pedal? your brake light is always on because the stopper at the brake switch is destroyed that's why it doesn't turn off. just put something hard to fill the hole at the brake
brake light switch stuck or bad Brake light stays on when car is off I had this same issue on my 97 Honda Accord SE, but when I changed the Brake Light Safety Switch, the problem was not solved! Turns
Question about Pontiac Bonneville
...brake light switch on the brake pedal ? I had this same issue on my 97 Honda Accord SE, but when I changed the Brake Light Safety Switch, the problem was not solved! Turns out the small blue ...
Question about Pontiac Bonneville
...brake light came on after 4x4 was on new brakes we put new brakes on 2006 explorer put 4x4 on turned off then abs brake light came on also wrench light came on when 4x4 is on wrench light goes off ...
brake light is on on my 2003 discovery (land rover) brake fluid leaking from the container Check your brake fluid level. If it is low, that light will come on. If the fuid level is ok, and the switch ...
brake pedal the tail light will stop working, in fact after some time the stop lights stopped working too, the problem was inside the socket, the ground wire was not making contact, I pulled the metal
...brake light switch is good. Polish off contact tarnish with a pencil eraser, or if it is severe, with a strip of Scotch-Brite doubled over the eraser end of a pencil or a dowel.Sometimes the solder ...
247 questions posted
Usually answered in minutes!
547 Questions
496 Questions
481 Questions
432 Questions
391 Questions