1997 Nissan Sentra "air intake knocking" Questions

...or loose. I am sending a guide to find the sensor too. It is located just behind your fan on the engine block near to the air intake. 1991 1994 240sx code 34 knock sensor detonation sensor ...

...air intake duct and air cleaner assembly. Then, locate the knock sensor and unplug the electrical connector. Remove the mounting bolts and then remove the sensor. Install the new knock sensor and ...

...air intake will turnover but wont start The 4runner hadn't been started since November when the Alternator and battery went, at that time a battery had been connected negative-positive for 2 ...

...air intake plenum remove the two lower air intake plenums remove the antifreeze fill port Knock sensors will be in the valley between the lower intake plenums. You will need to remove the rubber ...

...where the knocking happens-(fuel/air mixing). Mine was on the driver's side of the intake manifold between ports for cyls 4 & 6. Just below the fuel rail- two wire sensor. Hope this

expensive depending upon the wickedness of your local dealer. The labor? Probably a million or so. They are mostly mounted either in the Air intake, throttle body or as in toyota UNDER the FUEL INTAKE

1999 rx 300 3.0 knock sensor how do i replace a knock sensor? remove intake manifold and air intake chamber completely, the knock sensors are located in middle of engine

...air intake tube that runs from the air cleaner box to the throttle body on top of the engine.Loosen the clamp on the air intake tube at the throttle body with a wrench. Grasp the tube and pull it off ...

...air is in the intake to compute fuel requirements-map means manifold absolute pressure-look for it on the firewall or attached to engine-small black box with vacuum hoses, or at least one vacuum hose ...

plugs in behind the intake manifold air breather on the top side. If you remove the air breather cover it will help you get to it. It's not Complicated it's Just a process Of Changing the Knock Sensor