1997 Nissan Pickup "high pressure hose replacement" Questions

...high pressure hose. get some brake cleaner and clean the pump , hose and starter off . you can also get a dye and put in the pump to check where the leak is coming from! if its the high pressure hose ...

high pressure line has a hole in it. I used a florecent die kit to locate the leak. You can get it at Autozone. I am fixing my RV 1991 Dolphin which power by Toyota V6 3.0 engine; had the same problem

...high power steering pressure. Like when you turn the steering wheel, the pressure goes up, and it raises the engine idle speed. Find one in a junkyard, They have U-Pull IT yards around here, you can ...

...pressure ==== Check the ohm specification on the coil. ==== If the wires are over 3 years old then replace it Check and clean contacts ==== Make sure the wires are not cross. ==== Do a good carb. ...

...pressure regulator, but before replacing the FPR locate the fuel filter disconnect the line that goes to the engine and not the one that goes into the fuel tank put a hose on the tip of fuel filter, ...

pressure send switch, new rad...HC is 348 instead of 220 or below..somedays it passes high idle and some day it passes low but never passes both. Fuel consumption is high. What do I look for next? you

...pressure regulator. it could be Mis-adjusted or, faulty. replace this regulator asap. here are some other uncommon check points that i would inspect as well below just to be safe. 1. Coolant ...

...pressure raises to 43 psi and stays there until I put the line back on then hovers at 36-38 psi then surges and the motor shakes due to the rough idle. Any thoughts?! Thanks Again!!! ok i have the ...

...High speed miss noticeable at 1700 RPM like something kicking in. Want to remove Cruise suction but motor dies. How does applying suction to the Idle up valve increase Idle? Is my EGR Bad? Does the ...

...high pressure line connects to pump. i have replaced the o ring and it slowed it down but did not stop it. I have replaced the o ring twice. What next? Try some teflon tape on threaded end of hose ...