1997 Nissan Pathfinder "bad ignition switch cause loss" Questions

...ignition related items (Plugs/wires/cap/rotor), and it isn't a bad idea to replace the fuel and air filters if you haven't in a while. Once those are checked, it is very very common for a TPS ...

... What now? ASD relay gone bad? What';s with the alarm? There could be a bad battery connection or possibly even a bad ignition switch causing momentary loss of power to the Central Timing Module or ...

...bad ignition switch. According to the dealer the ignition switch contains an antenna that many of the sensors use to communicate with the vehicle, as well as the key fob. When the switch starts going ...

ignition switch sensor in a VW Jetta? Could it cause the car to shut down while driving? or Could it be the starter? Nothing yet its definitely not the starter, once you start your vehicle the starter

...class 2 most likely cause is the pass lock sensor is bad in the ignition switch. is the security light flashing also? if so then that is a good indication that the sensor will need

...bad ignition module. A simple way of testing the ignition module is to leave the car idling for 30 minutes and then tap the ignition module with a screwdriver. No Spark From Distributor To Plugs: How ...

...ignition switch to start - heard pop - no electrical power" - it turned out to be a negative clamp and a cable coming from the battery - the contact went bad and suddenly disconnected. The clamp ...

ignition switch could be bad. I would look to see if your grounds are burnt out. I just had same issue on my wife's 98 Honda crv. Two grounds were burnt out once replaced I had power again. So look to

bad check valve in the fuel pump (which requires a fuel pump module to fix) or a defective fuel pressure regulator or a leaking injector.To see if loss of fuel pressure after shut-down is the problem,

ignition switch , or melted wires, bad connections,something is causing a short when ignition is forward, could be a radio or any other electrical hook up ,tests with a volt meter will need to be done