1996 Nissan Sentra "green connector" Questions

Ad

Question about Nissan Sentra

1 Answer

...the car from the EGR vavle and slightly towards the center. It kind of stands on end. There is a vacuum line coming out the top (port C) and a green 2 wire connector plugged into it. Hope this

Ad

...connector) and the RED/BLUE (or RED GREEN) wire at Pin #8 are shorted to ground and the tail light fuse is blown (Fuse # 36, 10 Amp, in the Fusible Link and Fuse Box located in the left front of ...

Ad

Question about Nissan Sentra

1 Answer

...connector "D", terminal No. 6 (Green/Red wire on 2.3CL or White wire on Accord and Odyssey) and 25-pin PCM harness connector "B" terminals No. 20 or 22 (Brown/Black wires). If battery voltage is ...

...or black w/ the solid green? or does it matter? connect the solid green with the solid green. and the others. if you have the connector with wires just match the position right and left one by ...

...Green 6 Pin Black Square Type Connector(cut): (Top To Bottom - Left To Right) Grey Orange/Black Stripe Tan/Black Stripe Purple Green/Red Stripe Green/Orange Stripe 8 Hole rectangular Gray connector 7 ...

...Green (connector 1 pins 3 and 4)- Ground - Black (connector 1 pin 5)- Ignition power - Yellow (connector 1 pin 9)- Battery power - Orange (connector 1 pin 10)- R rear speaker - Light Blue and Dark ...

...GREEN (-) @ SJB, Connector A, Pin 14, See NOTE *1 TACHNOT RED or WHITE/RED @ IGNITION COIL or FUEL INJECTOR WAIT TO START LIGHTN/A BRAKELIGHT GREEN (+) @ SWITCH ABOVE BRAKE PEDAL FACTORY ALARM ...

Question about Cars & Trucks

2 Answers

... and it should come off. (one side, then the other) Then you will be able to depress the tab to unlock and remove the connector. (: green clip is a lock for black clip , just pull foward i would ...

Question about Nissan Sentra

1 Answer

...connector terminal No. 4 (Green wire). If resistance is one ohm or less, replace  MAP sensor. If resistance is more than one ohm, repair open in Green wire between MAP sensor  and ECM ...

Question about Nissan Sentra

1 Answer

that the green lock/slide piece inside the connector slides back into position, or the sensor could unplug. You need to push the green slide and pull on the connector at the same time to unplug sensor

Not finding what you are looking for?
1996 Nissan Sentra Logo

1,007 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...