1996 Nissan 200SX "need" Questions

when I start the car there is a loud noise as if a belt is turning and it needs to be lublicated. However, after the car has ran for a while the loud noise goes away but when I turn the wheel there is

...is not that easy or cost effective. The best way is to have a doner car that you can take all the needed parts off. You will need the clutch pedal, master cyl, slave cyl and hydolic lines. unless

...the bolts look like they slide up about 3/8 of a inch i can not find any info on this setting you need to buy an alignment rack, they cost a few thousand dollars, you will need a shop to install it ...

...has fuel and fire the motor cranks and attempts to start but doesn't any advice is helpful what you need to check is are you getting any spark at the spark plugs, to do this, unplug one of your spark ...

...all four new tyres .i took it to four different mechanics they all said different things .one said need a armbend so i got it replaced but there was no impact whatsoever .so i took it to 2nd one he ...

...the car's front end and locate it on the hood hinges. Place the bolts in loosely at first. You'll need to adjust them for proper fit. Open and close the hood to align and tighten the bolts when in ...

nissan sr20ve engine . Need specification for taking cylinder head apart and short block. Go to the public library. You will need to photocopy lots of pages.

I need the image to istall the timing chain on a 1.6 dohc engine, I need t see the marks this on a 95 20x nissan buy manual and read carefully before dissasembly

replacing timing chain I just need to know how to replace the timing chain on my car I believe you mean "Timing Belt" Major assemblies need to be removed as well as fuel rail depressurerized - Seek ...

...to measure temperature of air which enters engine is bad or its wiring is damaged/oxidized. you need to check for wires first. then you need to replace