1995 Nissan Pathfinder "engine revs accelerates slowly" Questions

in the case something goes wrong it will slowly get you off the road or home, but not let the engine rev to hurt the tranny more. Is there any warning lights on the dash? Check it out, hope this helps

Engine revs with slow acceleration (manual trans) I have a 97 Cav z24 with 98,000 miles. It is a manual transmission. The engine revs up to near redline when in gear when I press the gas but the car ...

...NEARLY STALLING THE ENGINE THEN SLOWLY GO BACK UP TO 900 RPM. SOMETIMES THEY DROP THAT LOW THAT IT STALLS THE ENGINE (NOT NICE GOING INTO ISLANDS) have the fault codes read and fix the faulty ...

revs even if I push the pedal to the floor there is no response, however after the engine has had time to warm up it slowly starts to rev up again and the vehicle is driveable but underpowered. Anyone

...revs the engine...and when im on flat ground going about 65mph in 5th gear when i go to accelerate it revs the engine but will not pick up speed as if it was not in gear. then when i let off the gas ...

...Engine revs normal until it reaches working temperature. when reach working temp. engine performance is a bit poor and it can?t reach max revs. it start to cut on 5400rpm in every gear, no matter how ...

...or if its not to bad run engine at 1500 revs and spray nulon carby cleaner in slowly to clean it out. have you found the source of the problem?...my hyundai accent is also having the same problem

...engine, start to backfire, no power,want to die on me, pls. help. while driving, car starts bogging, no acceleration, will idle, will not rev. keep pumping gas pedal it jerks slowly faster, pls. help ...

...engine is misfiring while trying to accelerate. After a while it runs ok, until you stop then occasionally it will run smooth, but will rev up on it's own while driving longer distances. Also ...

...just the throttle sucking air when the engine is under a load. When you rev the engine in park it wont make the noise as much or at all. Try driving it and slowly apply the gas and see if it