1991 Nissan Pickup "3 fuel getting oil" Questions

3: Viscosity chart SYNTHETIC OIL There are many excellent synthetic oils currently available that can provide better gas mileage, longer service life, and in some cases better engine protection. These

fuel dilution in the oil, leading to very rapid wear of timing chain, guides, and other sliding surfaces. 3 changes per year, 12 years, $20/change at 'jiffy lube' = $720, vs 1 change/year costing $240

...fuel line at carb and checked for pressure and that was good. really need help, someone please help. you probably have a vacume leak leading to vacume advance to listen for a vacume leak take a piece ...

...fuel will go bad and it will plug the filter and foul the plugs if you do those 3 things and in that order it should start it is important even though you have good fuel pressure that you replace the ...

3 teaspoons will run it) as long as it has fuel, air and spark. Hook up the fuel line again and start it up. One of two things will take place. 1. All is well! Great, it was just REALLY flooded. 2. It

...3.5 PSI fuel pressure, E1 is 35. today I own a PLUG IN, my wide band OXY sensor and can tune any carb. even while moving fast (logs) cost me $150 bucks. luv it. see red arrow that is the windwo. now ...

3 months. Then one night, I was pushing it pretty hard, it just died. I replaced coil and then was broke. After hours of looking it over, I noticed one of my ground wires on the intake was loose. Even

3 inches long to remove, both of which connect from the back side of the engine compartment, forward in to the starter housing. The top one is fairly easy to reach from underneath if you have the heat

...3 k Oil change, fiters and lube. I add Chevron gear armor to the trans and the rear end About every third replacement of fluids. If the "no lube" fittings are still on your truck, replace them with ...

...fuel pump if I turn the key on? I cannot hear the pump running. 2. The oil level was pretty low and I was wondering if there is an oil level safety switch? 3. Based on the compression numbers, would ...