2001 Chevrolet Malibu "oil put jack hammer" Questions

Ad

...Put you bolts in your container. Once the bracket is removed take off the rotor. Open the box with the new rotor then remove the rotor from the plastic. The new rotor is coated in oil for shipping to ...

Ad

...oil pan on a 02 kia sportage? Jack up car put on stands remove exhaust if it crosses under sump remove all the screws or nut bang side of sump with a rubber hammer to break seal,clean off old sealer. ...

Ad

Question about Chevrolet Malibu

2 Answers

...put new one on. It's not uncommon for the oil pan to get stuck. This usually happens if the gasket was not put on correctly and gunk gummed up the seal, essentially gluing it in place. Use a small ...

Question about Chevrolet Malibu

1 Answer

...can turn by hand if not hit it with a hammer till its freed up. make sure its in nutral and rear wheels are chocked. spray off ALL penetrant oil with brake cleaner before you put it all back ...

Question about Chevrolet Malibu

2 Answers

...oil not a spray and leave overnight ,then use a copper drift and a big hammer You can remove the stress on the bolt by raising the wheel hub assembly by hand or jack. There is a sweet spot that will ...

Question about Chevrolet Malibu

3 Answers

...oil is set). Repeat till wheel loosens. hopefully this helps The bearing cap section in the center is not normally the cause of this problem. It is typically from corrosion and dissimilar metal ...

Question about Chevrolet Malibu

2 Answers

...put spare on. Have jacked up car, taken four nuts off but wheel wont budge? She is rusted on ,you can spray it with some penitrating oil and let set a little then get a 2 pound hammer and hit it from ...

jack stand or blocking under frame at wheel.lower onto support.apply penetrating oil where center of wheel meets it's mount.strike wheel rim at tire edge with a plastic faced or wooden mallet[you didn

put the transmission in neutral to turn the hub and line up the hole to remove the bolts. 4) Knock it loose with a hammer and install in reverse order. The kit comes with a seal but I don't believe it

Question about Chevrolet Malibu

1 Answer

oil where stud goes through spindle,  hit the spindle with a good size hammer where the ball joint stud goes through the spindle (always hit what it goes through), give it several hard sharp raps

Not finding what you are looking for?
2001 Chevrolet Malibu Logo

1,494 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...