...TCCM) Self-Test. TCCM Self-Test Observe the transfer case shift control switch indicators while turning the ignition switch to RUN. A properly operating system will flash all indicators and then will ...
...tccm ,tested it with a test light and there is power.but no lights on the dash.no 4 hi or low or auto.what can it be. I have had luck over the years with unplugging the TCCM for about 5 minutes and ...
Question about Chevrolet Blazer
...killed the alternator, so the battery doesn't get charged. There are cheapo battery/charging system testers that plug into the socket, or your local auto parts store often offer free testing of the ...
...have a faulty transfer case control module which is located on the passenger side under the dash area right at the kick panel,there isnt any real test for this TCCM except replace with known good
Question about Chevrolet Blazer
...TCCM does not see these conditions the shift control switch indicator lamp will flash for approximately 5 seconds and then return to the original gear. Test Description The numbers below refer to the ...
Question about Chevrolet Blazer
...TCCM on a 96 blazer 4.3 cause transmission to not shift properly from 2nd into drive and overdrive The transmission will go into a neutral state, but when u let of the gas it shifts to drive and then ...
tccm and the wire harness that's goes to the shift motor the pins have 5 volts and pin 3 is less then 2 ohms so that checks out How about to the switch , is there battery power ? Fuse #15 FWD 10amp. I
...TCCM) Self-Test. TCCM Self-Test Observe the transfer case shift control switch indicators while turning the ignition switch to RUN. A properly operating system will flash all indicators and then will ...
Question about Dodge Cars & Trucks
...on whats going on dont know what wires to test to see if i got power to switch to tccm no lights on selector even after tccm was replaced On the transfer case does it have a floating wiper motor in ...
...TCCM) Self-Test. TCCM Self-Test Observe the transfer case shift control switch indicators while turning the ignition switch to RUN. A properly operating system will flash all indicators and then will ...
3,418 questions posted
Usually answered in minutes!
1,793 Questions
1,647 Questions
1,619 Questions
1,503 Questions
982 Questions