steps to obtain DTCs. Turn OFF the ignition for 10 seconds. Connect PIN 13 on the data link cable (DLC) to a ground. The DLC is located in the cab under the instrument panel on the driver's side. Turn
Question about Chevrolet Blazer
...Replace the transfer case shift control module. Refer to Transfer Case Shift Control Module Replacement . Did you complete the replacement? -- Go to Step 6 -- 6 Operate the vehicle within the ...
...replace the actuator motor. If the 4x4 actuator is working on the transfer case, then the front hub 4x4 actuator may have gone bad and that's located on the front differential. It's common for the ...
...replace the TCCM. Refer to Transfer Case Shift Control Module Replacement . DTC Displaying Turn OFF the ignition for 10 seconds. Connect PIN 13 on the data link cable (DLC) to a ground. The DLC is ...
replace board..due to bad connectivity on board... what is the name of the board so i can look online for a replacement secoind hand..? do you know.. thanks..jeff Take it to transmission sop but think
...transfer case and with a open end wrench, you can work the switch out and replace it with a new one and the cost is around $25.00 "Auto Zone / NAPA", Dealer $65.00. Good luck and keep me posted and ...
...transfer-case on the driver's side that has gone bad. It's common on out jimmy's and will need to be replaced. Auto Zone or Parts Source will have that part and can give you the step by step ...
transfer case two vacuum ports =2 lines one to and one from check those three it goes to a unit on the inside of the fender vacuum actuated too which actuates a cable in the front axle ---if it is NOT
...transfer case is bad, or the vacuum line to the switch isn't hooked up. If you do have vacuum there, then put it back in 2 wheel and put the line back on the actuator and put it back in 4 wheel. Just ...
3,418 questions posted
Usually answered in minutes!
1,793 Questions
1,647 Questions
1,619 Questions
1,503 Questions
982 Questions