2000 Chevrolet Blazer "rig brake lights" Questions

...brake light wires have been damaged or both rear bulbs are blown. The wires run down the left side of the Blazer frame from the left front near the drivers feet to the left rear and then across the ...

abs light is on brakes are fine does this rig have a speed sencer on the rearend like jeeps it's the sensor in the hub bearing that is the problem. These blazers are well known for these to go. You ...

...brake booster and ABS module? Thanks, Glenn Glen; you have a bad wheel bearing is what it sounds like to me so here's what you do.Jack the front of the rig up grab a wheel fromthe top and bottom and ...

...brake lights stay on, how do Ifix this you can rig it by gluing or taping a coin (the most common item used) to the back of your pedal where it meet the brake light sensor, or you can replace the ...

...rig. all grounds look good. all other lights work . just no power to the brake lights when i hit the brakes. my fuse's are also not blown. bad switch on brake pedal arm under dash or bad turn ...

brake light safety switch.. I had to rig it up so that it would work until I could go get myself a new brake pedal and have it put on. ( new pedal needed because that pin and its housing are one peice

brake light safety switch.. I had to rig it up so that it would work until I could go get myself a new brake pedal and have it put on. ( new pedal needed because that pin and its housing are one peice

...brake lights come on, turn them off and hit brakes and marker lights come on The filement within the bulb breaks. Sometimes, once broken the hot end can make contact with the other circuit in a two ...

...switch defective , Fluid level low or switch defective. What does the light say? I know in older rigs a light will come on from time to time

brake lights came on for no reason My husband was able to rig something up - all I know is whatever is faulting is up under the driver side way up in there - whatever he did (which involved tape) is ...