2000 Chevrolet Blazer "normal pulse reading" Questions

...normal over and over. was not uncommon to read this way on some GM products. Its ok. Now if the head lights pulsing while engine is running Alternator is going bad. Should have alt replaced and ...

...normal operating range, the VCM will set a DTC P0337 or a DTC P0338. Camshaft Position (CMP) Sensor The Camshaft Position (CMP) sensor is located within the distributor. The operation of the CMP ...

normal pulse width ranges between 1-5 milliseconds. If the PCM detects a signal less than 45 Hz DTC P0178 will set. How often have you have to replace the pump and how many times ? Just off the top of

...pulse intervals it receives, in conjunction with the CMP to resync the point of the #1 firing stroke. Any changes to the timed intervals at each firing order stroke is read by the pcm as a change in ...

normal. doesnt matter cold or hot has no codes When it doesn't start check for fuel pressure, spark and injector pulse. If you got access to a scanner that could read live data check if you get an

check engine light Stumbles on startup,barely runs, then suddenly runs normal.check engine light pulses, then either stays on, or goes out.. There could be too many reasons. Air filter, MAF sensor, O2

...drive the alternator is fine, but when I stop with truck running, the tach shows it going below the normal 550at idle. increase the idle to above 700. what is the problem with the alternator ...

I have 2002 Ford ranger 2.3l n I broke two teeth on the harmonic balancer that the sensor reads I assume will this stop the engine from starting? most definitely there has to be set pulses for the ...

...you first check to see if you are getting an injector pulse to the #3 injector (a noid light is normally used to verify the injector is receiving the 'pulse' from the ECM. The noid light is a

...pulse is at 38 and its over fueling like crazy coolant sensor is reading normal and it has 175 lbs compression on all 4 cylinders has good spark im stumped and im a mechanic been pulling my teeth out ...