...change it For 1993 Chevrolet Truck S10 Blazer 4WD 4.3L CPI 6cyl the Engine Control Computer is located in front seating area, passenger side, behind dash, above glove compartment cavity, mounted on ...
...change out on 1996 S10 blazer 4x4, or do I have to fight the two top transmission mounting bolts. Give me the simplest way to achive the identical engine (4.3)swap out. well pulling motor and tranny ...
...interchangeable and if not, the accessories on the front cannot be mounted. Bottom line is you need to replace the engine or short-block. Very expensive and better done by a more reliable
...front pulley, down low on the passenger side. It has 3 wires going into it. The camshaft position sensor in mounted in the distributor. It has a 3 wire electrical connector mounted to it. It's on the ...
Question about Chevrolet Blazer
...front of the engine. (on top) It is between the ECM (engine control module aka the engine computer) and the alternator. You will most likely need to remove the alternator and it's belt to obtain easy ...
...change them one at a time so you don't mix the spark plug wires. On the drivers side is work on the #1plug (towards the front) and #5 (towards the fire wall) first and do #3 plug last. Spark plug #3 ...
Question about Chevrolet Blazer
...change a starter on a 1992 chevy s10 blazer 4.3z engine v6 how many bolts and wires and stuff are there i took out two big bolts and the two wires and its lose but i cant get it out its stuck in some ...
Question about Chevrolet Blazer
...engine is running. The IPC will then interpret the speed pulses in order to appropriately display the vehicle speed on the speedometer. An electric speedometer drive is standard equipment on all ...
...change a starter?I loosened the two bolts to take it out and doesn't seem to come out of the space.Does it just come out or do I need to take off additional parts? If it's a high torque (small-body) ...
...change the fuel filter for a 2000 blazer. i try to do my own work. I did the diagnostic test at Auto Zone and the two codes that came up were PO 171 and PO 174. The truck does not acclerate good and ...
3,418 questions posted
Usually answered in minutes!
1,793 Questions
1,647 Questions
1,619 Questions
1,503 Questions
982 Questions