...hole out of the bed over the fuel pump to access? What are the dangers involved with accidental ignition of gas fumes or the gas itself from static shock? Is the fuel pump located in the front or the ...
Question about Chevrolet Silverado 1500
...fuel pump is located on top of the gas tank. I would not cut a hole in the bead of the truck, could cut harness or gas tank, it would be easyer to just remove the bed, four bolt's is all that hold's ...
...Fuel Pump. Not sure where on a 2000. On My 95' it was Inside the Under Hood Fuse Box, Had to replace a Relay swith too. My advice is to get a Haynes or Chilton Manual for your Truck. That will help ...
hole in the hose on the fule pump housing. He replaced the hose. It would try and start and again cut out. He checked to see if power was going to the pump it was and he could hear the pump start when
...hole to access fuel pump....is that need to cut a hole in 93 Trans Am to access fuel pump....is that a possibility? I know this is not the "right" way, but can it be done? if so how? it would have to ...
fuel pump Where do I cut the panel hole acess on a 91' park to remove the fuel pump? You don't cut an access hole. You have to remove the fuel tank.
Question about Cars & Trucks
...hole for fuel pump 1993 olds cutlass supreme convertible Where would I nedd to cut a hole in the floor for fuel pump access ? Don't cut anything. Drop the tank. dont cut the trunk un bolt the straps ...
Question about Cars & Trucks
...hole for fuel pump on my 2000 taurus You do not cut a hole, you remove the tank from the vehicle to access the pump. Never cut holes with any device or means near a gas tank . Any copies are VERY ...
Question about Ford Cars & Trucks
...fuel pump for a Ford is very high and a pain to replace. I have removed my bed liner and cut a hole into the bed over the tank to get to the pump, if you do decide to cut a hole, only cut 3 sides and ...
...Cutting a hole in metal above fuel pump is way easier than dropping the fuel tank. Avoid sparks though! A shortened oiled hack saw blade on a jig saw may do the trick. Cut three sides and bend panel ...
6,290 questions posted
Usually answered in minutes!
159 Questions
130 Questions
67 Questions
56 Questions
12 Questions