...chevy truck. the old engine and generator were swapped out with a 1983 350 V8 and 12 vlt alternator. The new electronic ignition module was burned out by the mechanic during installation. the second ...
Control module where is the control module located in a 1997 chevy silverado one ton truck? Which control module? Ignition control? Engine control? What engine?
...Chevy Truck K1500.What else could be wrong.New cap and rotor.This no start came on sudden with no warning i have a 98 chevy 1500 5.7 motor,fuel pump is good,oil pressure switch is good, relay, ...
...chevy truck which sometimes starts and runs fine, but after its shut off it will not restart. I have had recent experience with a chevy S10 that had a similar problem, which turned out to be a ...
...chevy z71 4x4 pickup i have no spark and a cod p1361. new relutor cranks sensor and still no spark whats the problem PO 1361 ignition control circuit low voltage. Check your ignition module and
ihave 1990 chevy silverado 1500 350 mototor i have no spark i put on new coil and new ignition coil rotor cap change the ignition module in the distributor.
...chevy 1500 pu loses power when it warms up, new coils new ignition module new plugs new wires no change, runs great when you first start it, when it warms up, idles ,no power,bogs down at 2000 rpms ...
...chevy suburban will start when gas is poured into the intake but will not stay started check your entire ignition system especially the ignition control module Did you pressure test the fuel at the ...
The truck is a 2006 chevy it cranks and has fuel but has no spark ignition module or crankshaft sensor are the usual suspects. Hope this helps.
ignition module on 1996 chevy 5.0 vortec Remove the distributor cap then the rotor and then remove the wire connectors hook to the module then remove the 2 screws that mount it to the distributor.Make
1,299 questions posted
Usually answered in minutes!
795 Questions
754 Questions
575 Questions
561 Questions
414 Questions
