1998 Chevrolet K1500 "98 chevy truck 5 runs" Questions

98 chevy k1500 4 wheel drive 4.3 will not start when try to start will turn over good but will not start but if i jump it and turn the ignition switch on and off fast and let the motor turn over for a

98 chevy pu 2500, 2 wd with a 5.7, replaced the fuel pump, replaced all 8 injectors, along with fuel pressuer regulator, + a new inline filter. 0nly getting 44psi, won't start unless I use spray start

...98 chevy silverado 1/2 ton 5.7L motor. My truck will only start after I turn the key over and over to allow the fuel pump to run. I sometimes do it 10 times before it actually starts. After its on it ...

98 Chevy K1500 - Wire off road lights to work with brights. Just bought 2 off-road lights and mounted them to my brush guard...but would like wire them so they turn on with the brights/high beams.....

98 5.7 chevy runs 5 sac then stops 98 5.7 chevy runs 5 sec then stops changed the fuel pump and filter still the same make sure pump is getting power and is grounded right and also check fuel pump ...

...light on the dash, go to this link for answers. Gm are notorious for failing antitheft systems http://vatspasslockpasskeysecurityhelp.yolasite.com/ 98' chevy venture start but wont stay ...

98 chevy blazer Replaced every part that was reading a code. Still runs bad Still jumps & bucks erratically. No matter what I replace it still runs the same. Engine runs smoothly but once in gear it ...

...98 V 6 chevy malibu idle go up and down and if you push gas it runs but when you let go gas idles down to 5 and go up to 6 -7 and it's doing that rapidly,do you know why? please help First check the ...

98 chevy 1500 4.3L vortec misfire problem i have a 98 chevy 1500 4.3L vortec I've pulled off all the wires and checked for a spark all but #5 sparks i changed the wire set and have the same problem. ...

...Chevy S-10 Pick Up with the 4 ... car a few times, what essentially you are doing is priming the fuel pressure. ... A dirty fuel filter will not cause the lines to lose pressure after the engine is ...