1997 Chevrolet Suburban "replacing front axle olds" Questions

...front axle actuator and applied 12 volts to the leads. The actuator came out kind of slow and retracted when I removed the power. The metal section were the wires go in also heated up. Is this normal ...

front bearing arrangement often found on FWD and 4WD vehicles is often nonserviceable.These bearings are pressed in and out of the hub to be replaced. To do this, the axle or half shaft is removed, as

front, had axle replaced, could this have been prevented or is it natural wear and tear? Is a axle oil leak normal wear and tear? Hi Dolores ! by replacing the axle shaft have you changed also the oil

...front end until the drive shafts were replaced. Now the machanics cannot figure out why my car now has a wobbling problem. Can you help me out with a solution? make sure the new axles match up to ...

...front axle its a 3.73... One month later front diff is heating up and humming,I think its going out again.. is it same gear ratio as old one also double check to see what ratio rear one is if someone ...

...Do the same on the old axle. Replace bearing clip, cv shaft and reassemble. Do not try to remove the part from inside the front axle unless you want to spend about six hours of time and

...front axle on 1998 ford windstar van you jack it up and remove the axle bolt and and tie rod end and slide old one out and new one in old one may be kinda hard to pull out from age but give it a tug ...

...front drive axles. It stopped when I replaced the driver's axle, but returned in about 5000 miles. needs changed again could have been a cheep faulty one check warenty with part and return hope this ...

...front axel shaft Old technology dana axle, i believe. If so youll need the brakes off and rotor and the whole wheel bearing hub assembly(i believe bolt in with 4 bolts) this leaves pretty big open ...

...FRONT END OUT OF ALIGNMENT COULD CAUSE PREMATURE WHEEL BEARING DAMAGE.ALSO ROAD WITH A LOT OF POT HOLES WILL DO WHEEL BEARING AND AXLE DAMAGE.QUESTION YOU ASKED ABOUT REPLACING OLD AXLE WITH 2 PIECE ...