...GMC 4.3L V6 on a distributor Remove the cap and mark the rotor to the distributor housing so you reinstall it in the same place.Remove the rotor from distributor and put it on a vise.On the bottom ...
GMC Sierra 350 cu.in. 1995 GMC Sierra P/U with a 350cu.in. Disconnected tan wire with black stripe, timing set at 0' BTC as soon as I reconnect the timing advances 20+ degrees and stays there, causing
...gear. like not getting enough gas. Need to verify air, fuel, ignition, and computer codes. Is there a fuse blown or bad wire connection on battery, alternator, or grounds to frame? For TBI ( Throttle ...
GMC Sierra 1500 that wont stay running The engine starts but wont stay running unless you continually rev it. The injectors spray fine and the fuel filter was recently replaced. It used to run but sat
...GMC 1500 Sierra 4.3 will not start acted like out of time so I replaced cap rotor plugs check plug wires .also replaced timing chain and gears even though no problem also changed ecm any ideas The ...
GMC K1500, 5.7L has no spark. New battery and ignition coil. Is parked on a slope headed downhill towards the driver side. Remove the distributor cap while cranking, see if the rotor turn. If not then
...gmc sierra 1500 stalled and will not start. 2006 gmc sierra 1500 stalled and will not start. changed fuel pump, distributor cap, rotor button, ignition module, cam sensor, and crank sensor. getting ...
...distributor gear was too soft and prone to wear. Here's the proper procedure to replace: http://www.fixya.com/cars/t3398434-distributor_gear_worn_timing_retarded_15 You could also exchange the entire ...
...sierra 1500 ext cab pickup have had to replace almost everything the truck just slowly died back fired real bad but now I am having problems setting the timing right inspect distributor gear and cam ...
286 questions posted
Usually answered in minutes!
584 Questions
420 Questions
403 Questions
331 Questions
284 Questions