1993 Chevrolet Suburban "wire tail lights brake 93" Questions

tail lights, dome lights, horn. I replaced the light switch, that did not help. The fuses are good. I do have brake lights and turn signals. Where should I look? What do I need to replace? ck the wire

...tail and License plate lights would light with either the Headlights or the "Parking" light selected at the switch as would the front parking lights. If all lights except the headlights are out, your ...

...wire (rear park light) in passenger-rear tail light harness (behind wheel hump cover) shows no voltage with park lights on. What is the power path (wire paths/locations/colors and module locations, ...

tail lights on 93 crown victoria do not work but brake lights and turn signals do remove lens & check for corroded wire or bulb/socket. Then check bulb (2 filaments). Clean any corrosion on ...

...tail lights or dash lights, where should i start looking. I checked all the fuses and they are all good and i took out the headlight switch and one of the wires appears burnt. Could that be the ...

...tail light asseblise connector pin to board poor connection or burned push in light bulb sockets On my '93 Chevy PU the new ones went bad within months I repaired the original ones by soldering all ...

...tail lights go out and the only light in the rear comes from the red markers at the extreme corners. After troubleshooting at the local mechanic, the lamp failure box in the trunk was burned out ...

...tail lights work, no brake light on left side, also turn signal on left doesn't work, new brake light switch new bulbs, new bulb holder any good sugestions Your rear left side combo lost a ground on ...

...tail light, turn signal i have a 93 chevy K1500 an the driver side brake light only works when the right turn signal is on? The red running lights work but when u hit the brake the light doesnt come ...