2004 Nissan Sentra "change belt tensioner pully" Questions

...change drive belt for my nissan sentra ser spec v how do i get to the tensioner to change it free the engine from the compressor and then remove the plug then first insert the drive belt on the ...

How to change the tensioner pully on a 2004 nissan sentra 1.8 you will have to remove the serpentine belt first and then there should be one bolt holding it on

...the cranks shaft pully is shaking and i hear a noise like a rattle or chirping. is it due to the drive belt tension. No the pulley grooves are a sleeve around the crank. this sleeve will break

...U dont need no diagram or picture to change the belt just look how your old one is on there and change the belt by unscrewing the alternator bolts and push the alternator down and take the belt

...Change belt. Check alternator for output 13.8V to 14.2V Check for ripple alternating voltage from worn/old alternator. Test for 0.1 volt ac at 1500 rpm Any reading over 0.1 Volt ac is a fail ...

...belt,idler pully,tensioner for 2004 lexus ls 430, when start engine has a noise look like from pully After shop changed a timing belt, idler pully,water pump and tensioner, when start the car engine ...

...change serpentine belt on 2006 buick lacrosse Start by drawing a diagram of the belt routing. Serpentine belts normaly have 1 spring loaded tensioner (1 pully will have a nut or 3/8 or 1/2 inch drive ...

...CHANGE A/C COMP. BELT ON HYUNDAI XG 350 loosen tentioner pully belt... using a 14 mm wrench, release tension on the belt by loosening the 14mm bolt. when loose enough, remove belt.. then install NEW ...

belt off to change the pulley. Tell you what... No response, then I can't help. If you're talking about the accessory drive belt tensioner pully, there are two 12mm bolts which mount it to the engine.

change serpentine belt .05 UPLANDER pasenger side of the car ther will be a Tensioner pully (wheel) stick a 3/8" scocket on the wheel ( there is a place for it) and move it to the Right (drivers side)