1996 Nissan Pathfinder "terrano brake" Questions

...brake hoses off the nissan terrano alternator or just disconect all the hoses off the back of the alternator and connect them with no problems??? Some (most) Terranos have a vacuum pump attached to ...

...this little problem on my terrano thanks' It's good to have the rotors turned when you replace your brake pads. It should not cost too much. And it keeps the new pads from wearing down so

...brake light circuit on a 97 G3MR Terrano. All lamps failing to light so assuming fuse is at fault? Most of the time you can find the fuse panel either on the driverside under the steering column near ...

...Terrano 4x4.Thishas an Automatic trans. It will not change gear.I have a power/hold button next to the hand brake.The power light flashes If the power hold button switch On,It will stop the gear ...

...Terrano II has a very soft clutch. The peddle occassionally drops to the floor and I have to lift it and pump it a couple of times to reactivate it. It then works OK for a while. Master cylinder ...

...Terrano are a magnetic pick-up, which senses the passing of the teeth machined into a steel disk on each wheel. If the ABS computer codes are indicating the G sensor, then that is probably what is at ...

...terrano 2 goes into reverse fine, when put into drive, the engine has to scream to engage gear and go anywhere. can anyone help. it's a 2.7td with an auto box. have you checked the transmission fluid ...

The brakes on my nissan terrano 1993 has got very hard what could be the problem there is no fluid leak and the fluid bottle at the booster is full. The servo isn't working. This is a very serious ...

...terrano. im trying replace the brake rotors Take the wheel off. then the grease cap. There will be a keeper that has 2 screws, take those out, then remove the keeper. You will see another keeper, but ...

...out from the servo. can the vaccum pump be taken out and serviced by a home mechnic its for my 1993 terrano 2.7D your bake booster is powered by a vacumn hose on intake manifold I just happened to ...