1995 Nissan Maxima "stalls unplug maf" Questions

Ad

Question about Nissan Maxima

3 Answers

1995 nissan maxima bogging 95 max battery new, today no problem starting, engine running ok on idle then, at 2000rpm motor bogs losses power. changed fuel filter, air filter good. Watched air intake ...

Ad

Question about Nissan Maxima

4 Answers

MAF sensor by the air cleaner box, take out the two screws but unplug it first, and inspect it for consensation oxidizing on the contacts, if you see it take an old toothbrush and lightly scrub it off

Ad

...stalls. I did notice that today the rpm needle does not move from 0 for about 10 seconds. First time I have seen that check the map sensor. If you unplug it and notice no difference, then it is your ...

Question about Cars & Trucks

1 Answer

2ltr astra tdi wont go above 40mph More than likely MAF sensor? Maf sensor located on main air flow pipe after airfilter. Try unplugging vehicle may stall or even put management light on but if revs ...

stalls when MAF is connected My 99 Grand Prix GT was running fine and then when I turned it off and tried to start it when leaving somewhere, it wouldn't work. It was like it would ONLY run when cold.

...unplug the mass air flow it will start and run and if plug it back up it will stall out. sounds like bad MAF to me(mass air flow sensor) I have 95 taurus, would not start, 5 days later after dropping ...

...stalls out quickly as if not getting gas Try unplugging the MAF sensor. It is located on the top of the throttle body. It should have a three wire connector. If the car now starts and runs than I ...

nissan 300zx turbo will no start with Mass Airflow Hey Does anyone know about a problem that can causse the car to start correctly without the MAF Sensor and stall when I put back the MAF. No codes ...

When the maf sensor is unpluged the truck will start up great but if plugged in will idle rough when cold starting and want to stall. MAF sensors get dirty and wear out. Replace it.

unplug MAF sensor Replace maf sensor 2013 , long ago, but the CEL lamp flash codes tell you what failed. unplugging the maf drops ECU to limphome mode. if engine is super lean or rich that can help it

Not finding what you are looking for?
1995 Nissan Maxima Logo

1,542 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2000 Nissan Maxima
2000 Nissan Maxima

1,309 Questions

1996 Nissan Maxima
1996 Nissan Maxima

1,007 Questions

1997 Nissan Maxima
1997 Nissan Maxima

857 Questions

2004 Nissan Maxima
2004 Nissan Maxima

783 Questions

2001 Nissan Maxima
2001 Nissan Maxima

480 Questions

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...