remove radiator hoses and clutch cable, trans mounts, etc to gain total access to transmission. I also believe you will have to remove one of the rotating parts above as well as the air intake to gain
Question about Nissan Pulsar
...replace the clutch kit on my front wheel drive 1982 Datsun/Nissan Pulsar but does not know how have removed the bolts and the starter already follow this link , register , its free , they should have ...
...clutch control circuitry. In my case, I removed the entire aircon control assembly. To get to it, it is necessary to start at the top panel, centre of dash. It prises off. I don't remember the entire ...
...compressor faster thus charging the system sufficiently to dis-engage the compressor, which in turn removes the load from the engine, allowing it to idle again. A simple way to test is to disconnect ...
...Remove clutch release lever dust shield. Disconnect clutch release lever cable from clutch release shaft. Remove retaining clip, then clutch release lever cable from flywheel housing. Remove starter ...
...remove fan clutch, fan blade and shroud from vehicle. Remove four screws and separate fan clutch from fan blade. Item Part Number Description 1 8509 Water Pump Pulley 2 57632-S Screw and Washer ...
...remove clutch fan you need to remove upper fan shroud, you need large wrench to remove the fan clutch retaining nut to remove fan and clutch away from the engine drive belt should keep pulley from ...
...Remove the A/C clutch hub retaining bolt. Hold the A/C clutch hub with the special tool. Remove the bolt. Remove the A/C clutch and the A/C clutch hub spacer. Thread an 8 x 1.25 mm bolt into the A/C ...
...remove the clutch from the shaft of the compressor. Once the retaining bolt is removed, as described in Step 1, simply pry the clutch away from the mounting surface using your hands. If the clutch is ...
Question about Cars & Trucks
...Remove the clutch pedal from the support by depressing the side tabs. Installation Procedure Position the clutch pedal into the support. Secure the master cylinder rod to the clutch pedal. Good ...
131 questions posted
Usually answered in minutes!
331 Questions
65 Questions
52 Questions
21 Questions
16 Questions