1987 Nissan Stanza "ecm mod" Questions

...control module location if the engine control mod burned does that prevent the vehicle from starting? Yes if the ECM is defective the car wont start, the ECM controls the fuel injection, spark ...

to normal operating temp I have replaced the coils and mod under the coils also has new tps and idle air sensor and new rebuilt Ecm no codes on Ecm check the crank shaft sensor.need a scanner to do it

...mod 1996 dtc codes, i look to the ecm and does not have any switch to change to self-diagnostic mode. thank you There is a connector under the steering column, you need to buy an OBD 2 system scanner ...

...Mod & pick-up. All showed to be bad with OHM meter. 20A ECM-B fuse keeps blowing out and I'm afraid to burn these new parts up.... ANY IDEAS OUT THERE??? The 20A ECM-B fuse was bad replaced and ...

...ECM,fuses,relays even got new injectors still cannot get my injectors to turn on Hi there, Joel here 20 year master mechanic. For the faulting to the injector pulse and power, the control mod in the ...

...MOD $00 I would try disconnecting battery again. Disconnect both cables and touch them together for a few seconds. This will reset all modules. Wierd that you had so many codes after just ...

...ECM-B fuse. Replaced Ign Mod,Coil,Cap/Rotor & pickup. Any Ideas Out There? Afraid to go any futher...dont want to ruin these new parts! if you keep blowing a fuse there's a good chance it's not a ...

...mod for my 2009 Kia optima, where is it located and will I have reprogram the ECM Why do you need to replace the airbag control module is the better question... Well, the ECM should be fine with the ...

ECM at 5v,5v meter and 12v test light, &gnd (ABCD), Ign Cntrl Mod now at 12V DC at A&D pins w B pin at 2.8 V AC & C gnd. Initial code 41 on dashboard diag and now cleared after replacement

when engine get to operating temperture it stalls and hard to restart sounds as though your timing is off a little!!! pull codes off the ECM old cheap reader will work . but I think ign. mod.