1985 Nissan King Cab "pump oil" Questions

...oil pump, etc. The engine runs properly, but no oil comes, whil;e pump is ok? i dont remember if the oil pump runs off the distrubiter if it does there should be a shaft that runs the oil pump either ...

...oil pump. remove oil pump/distributor drive shaft, noting the orientation of the drive shaft. Remove harmonic balance using correct puller (can be rented from local auto parts store). Remove P/S pump ...

...oil pump? some cars have a oil level sensor (in the oil pan) these can go bad or the oil pressure sensor can go bad. DOES YOUR MOTOR MAKE A TAPPING OR KNOCKING SOUND AT A IDLE WHEN WARM ? IF SO . NOT ...

...simple tools. If not running, the problem could be your oil pump or any one of several other possibilities. There's really no way to narrow it further without having it checked by a mechanic. Bill ...

...have worn valve stem seals! they can be replaced without removing the head using a compressed air pumped into each cylinder to hold the valves up! you can then remove rockers etc & slied on new ...

body trucks and get a computer form one of them it should be like $100 if that isnt it then pull the head off and check that and rebuild the head for like $100 that or your oil pump could be a problem

...oil pressure light gose out then it cuts out then hard to start but is ok when warm can any one help please? thanks james Hi james, you might have air in your injection system. ussually this air ...

...oil pump alignment (even following the manual and calling a couple of import buddies didnt help) and as a result the distributor is advanced wide open which gets it close but not quite right. These ...

...pump - the old one is too small for the amount of fuel required in the turbo motor; then you will need to completely alter the lubrication of the engine to insure it for the turbo - it implies the ...

...oil pump in 2007 gmc yukon Can you get to the oil pump with out taking the engine apart You have to remove the engine front cover (over timing chain) and remove the oil pan to get the oil pump in and ...