1983 Nissan 280ZX "ignition removal" Questions

Ad

IGNITION FAILURE ON 280 ZX (82) Vehicle was running fine while i was working on vacuum for air con, revving fine ,idling fine went to move it and car just died, fuel pump still seems to be working ...

Ad

need to replace 280zx ignition lock cylinder can remove steering lock but cannot seperate lock cylinder from steering lock. we have a 71-681. we don't have a key. Look at these and tell me which one ...

Ad

Question about Nissan Z

2 Answers

...may re-start sooner, but engine sputters and spits for a short while, then smooths out.. Possible: Ignition Coil failing when heated up? OR is mixture too rich for hot engine? (Fuel Injected ...

Question about Nissan Z

4 Answers

280Zx ignition problem Anyone have a wiring diagram for a 82 280ZX Turbo datsun? It only wants to start t times and acts flooded most of the time. Your car should be a L-28 1,5,3,6,2,4 on the cap ...

Question about Nissan Z

2 Answers

...there. Intake backfire is usually caused by running lean or improper timing. For the 79 model zx, ignition timing was 10 degrees BTDC @ 700rpm For 80 and up zx, non turbo - 8 degrees BTDC +- 2 ...

...Ignition Coil Removal Remove the air cleaner outlet tube. For additional information, refer to Section 303-12 . Remove the bolts and the ignition coil cover. Disconnect the electrical connector from ...

...Ignition Switch Lock Cylinder Removal Remove the steering wheel (3600). Refer to the procedure in this section. Remove the four lower steering column shroud screws. Separate the upper and lower ...

instructions how to step by step replace ignition lock cylindor for an 1999 oldsmobile intrigue 1999 Oldsmobile Intrigue IGNITION SWITCH AND LOCK CYLINDER REPLACEMENT 1. Disconnect battery 2. Disable ...

Question about Nissan Z

1 Answer

...Ignition Switch Removal Disconnect the battery ground cable. For additional information, refer to Section 414-01 . Position the LH instrument panel insulator aside. Remove the pin-type retainers. ...

How to change a coil pack on a Chevy Tahoe To Remove...... 1. Remove the spark plug wire from the ignition coil. 2. Disconnect the ignition coil electrical connector. 3. Remove ignition coil bolts. 4.

Not finding what you are looking for?
Cars & Trucks Logo

204 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2006 Nissan Z
2006 Nissan Z

21 Questions

2008 Nissan Z
2008 Nissan Z

2 Questions

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...