1986 Nissan Pickup 4WD 1986 "resistance toyota pick coil" Questions

...toyota 2wd pick-up truck has no spark at the coil, the guys at auto - zone tested the coil for resistance and it check ok. the rotor turns when I crank the engine, what else should I check.- Hello i ...

...pick up coil projections are less or more than the correct--.008-.016". If so, the bearing is bad (the star wheel will wobble) and you should replace the distributor. Also, the distributor has three ...

...toyota truck won't start 22R-E. It had stalled a few times while driving. If it sat for a little while it would start up. the third time it wouldn't. I noticed the distributor cap was ...

...toyota carinae gli with 2lengine i did not find it in the list If theres no spark from the spark plugs then you would have to replace them? On models equipped with external coil, ensure spark occurs ...

...resistance depending whether you are California or excluding California California is cold- pick up coil terminals G1 & G- Ohms 125-200 cold-Pick up coil terminals G2 & G- Ohms 125-200 ...

...Toyota Camry. I was driving on the hwy at 60mph when it just died. No fire. I had to replace the distributor a few months ago when the same thing happened. I checked the coil and found the primary ...

pick up coil acts as a cam sensor here is crank sensor info the crank sensor is located in front of engine just behind the crankshaft pulley using ohmmeter check resistance between terminals on sensor

...resistance, primary and secondary ok. Power to distributor 12v. While cranking coil output no spark. is it actually rotating when the engine turns over I know sounds ****** but I've seen the teeth ...

...toyota tercel ''hesitation and lack of power'' I have replaced dizzy rotor and cap, plugs and wires, and O2 sensor. I sprayed stating fluid around the vacuum hoses and intake manifold and components ...

...resistance [4A-FE & 7A-FE both = 9.0 - 15.7 kilohms]. If either of these values is out of spec, the coil will need to be replaced. If everything is OK, next check the air gap between the signal ...