2005 Mercedes-Benz Mercedes Benz E320 Cdi "knock top left engine" Questions

Ad

Question about Mercedes-Benz E320

1 Answer

left as far as you can( if you look at the top of the advancer you can see the mechanism resting against the housing) If you do not the cam will over advance and hit a piston. Time the exhaust cam and

Ad

...top, just off idle . problem is new, severe on rev, steady but not severe on steady rpm. erratic all ways Unfortunately, it sounds like you have a spun bearing. This is a severe engine problem that ...

Ad

Question about Mercedes-Benz E320

2 Answers

...top end around the left of the engine, initially I thought the problem would be camshafts so I have taken these out but they are OK. Can the VVT pulley cause a loud knocking like this? Any other ...

trying to find the knock sensor on a 2001 mercury sable help me locate the knock sensor on a 2001 mercury sable The knock sensor is located in the rear on the left hand side on the top of the engine.

Question about Mercedes-Benz E320

2 Answers

...knock pin on the camshaft. Water pump, using a new gasket. Tighten the nuts/bolts to 53 inch lbs. (6 Nm). Rear timing belt cover. Tighten the 6 bolts to 74 inch lbs. (9 Nm). Engine wire with the 3 ...

...knock sensors are bolted directly to the engine block. they usually have two wires. Some are on the top, bolted to the intake manifold (v6 or V8) others are bolted to the side of the block, either ...

...left for around an hour when I start it up there is a knocking noise from the top end, it only lasts for about a second and than all goes quiet.. if I switch the engine off and restart, the knocking ...

...knock sensor is most likely ok you need to do a top engine clean to get the combustion chamber presure down so the knock sensor can ****** the timing enough to not knock or ping, You may not here the ...

Question about Mercedes-Benz E320

1 Answer

...BLOCK TO THE LEFT OF THE KNOCK SENSOR. THE 2.4L ENGINE CAMSHAFT SENSOR LOCATED ON FRONT CAMSHAFT HOUSING TOP COVER LOOK DOWN ON TOP COVER WHERE IT SAYS 2.4L TWIN .SENSOR BELOW T ON TWIN ON TOP

Question about Mercedes-Benz E320

4 Answers

knock Sensors are located under the Intake Manifold at the top of your engine. The top will have to be taken off along with the intake manifold. Knock Sensors in past silverados used to have a problem

Not finding what you are looking for?
Cars & Trucks Logo

734 questions posted

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...