2002 Chevrolet Silverado "remove plastic intake cover chevy" Questions

...up in the back. It takes a large socket to remove, and is a very tight squeeze. The sensor looks like a black plastic cylinder sticking up in the back of the engine with a wire connector on

...order to fix the leak,the black plastic cover over the intake manifold needs to be removed or at least loosened.Any idea how this cover can be removed? remove oil cap steam an it should just lift ...

...plastic cover over the intake manifold needs to be removed or at least loosened.Any idea how this cover can be removed? mine is doing the same, it's your pcv receptor on the manifold. that hard ...

...intake plenumn. (The black plastic cover that sits on top of the intake manifold) After removing this upper intake, the regulator will be on the back side of the fuel injector inlet housing. Good ...

...remove the engine plastic cover that says Chevrolet 3.4L. You do this by disconnecting the electrical wire from the oil pump located on you left side and unscrew the entire oil fill spout. Then just ...

...plastic cover that says relays . Other chevys like the 4.3 use a back up system that makes the fuel pump work through the oil pressure sending unit even if the relay is bad it will start and run ...

...remove the air duck and the engine plastic cover where you cap the oil cap..to access the fuel rail sensor you'll need to remove the air intake which is a back intake where the body throttle is ...

...Remove the plastic cover from the top of the engine, remove the snap ring that holds the regulator in place. Pull out the regulator. Be prepared for fuel to spray or spill. Make sure all the parts ...

...plastic mud flap behind my front tire and blew out all of the leaves and rotted debris that where behind that flap. It was packed with junk! I poured more into the 1/8" hole and it seemed to drain ...

...plastic cover) is a spider legs injection system. that is one main body and up to eight legs that simply clip into the heads. Over time, crud gets into the passage that the injector goes into and ...