2002 Chevrolet Silverado "rear drive axle seal" Questions

rear differental cover, remove locking bolt, (5/16) remove center rod, remove axle retainer clip, pull axle out, pull seal out, using a socket drive your new seal into place, Install in reverse order,

...rear also had driveshaft balanced,what esle could itbe You will need to check things logically. Run the truck in the air and note where the vibration is at. Take the wheels OFF and put a few lug nuts ...

...loose). Also: axle shaft bearing - worn/damaged/dry. Replace or lubricate (if dry). Here's the 2000 Silverado rear leaf spring front shackle: Here's the 2000 Silverado rear leaf spring rear

Drive the bearing into the housing until the tool bottoms against the tube. Lubricate the seal lip and install the seal with a suitable seal driver. Make sure the seal is fully seated in the axle tube

...IS rear wheel drive right? Yes there an axle seal at the end of the axle shaft, remove rear end cover remove 8mm bolt slide pin out remove horse clip slide axle out remove outer seal and replace

...back on . Then refit in reverse of removal and bleed the brakes and top up the rear axle of oil (EP90) apply h/brake take out blocks and lower jack and test drive .. BUT MAKE SURE THE BRAKES ARE

rear of the truck. you will see side gears with the shafts axle end at each side gear. a C clip will have to be removed from each shaft at the end of each axle. Then remove the wheels and pull out the

...drive rear wheel bearing replacement what about it? conventional axle or limited slip? Get axle code off door sticker. SECTION 205-02: Rear Drive Axle/Differential - Ford 8.8-Inch Ring Gear 1998 ...

...rear wheels,take off the diff cover,remove the 5/16 pin that holds the big pin,pull the big pin ,push in on the axles,remove the 2 c clips that are on the axles and slide the axles out.If the axle ...

...drive. i checked the tire and it is fine as well as the rear diff fluid. the noise starts around 30mph and continues untill i reach 30 or below mph. the car does not shake at all, just the noise. Any ...