2000 Chevrolet Tracker "replace rear differential seal 4wd" Questions

...rear axle seal, and refilled the differential with oil. Wife drove home from garage yesterday. This morning car felt like it was stuck and only moved a few feet. Did not roll in neutral. I put it in ...

...rear differential) and it's hard to guess which one cold be defective. Depending on if your maintain your maintenance up to date my guess is that few seals will have to be replaced. Hope it will help ...

...replace rear axel wheel bearing and seal on 2006 jeep liberty renegade 4wd its not just the seal.... i bet, 99% of seals that fail are , the bearing is allowing , out of spec. moving in the axle so ...

...rear differential? you should only change any diff when damaged or if a different ratio is required and being a 4wd both diffs would need replacing with change of ratio, oil in the diffs should be ...

...replace the rear bearing ????? this is a 1986 toyota 4x4 pickup rear axle bearings.. manual trans. There are 4 bolts for each rear axle. They are located behind the rear brake drums. Remove e-brake ...

...rear differential was rebuilt with new axles, bearings, seals plus differential was replaced at a local (trusted) mechanic shop, +carrier & pinion bearings, new crush collar & pinion seal (147,500 ...

...differential by passing through the PTU. The PTU then drives the driveshaft at all times. The driveshaft drives one half of the rear axle clutch pack. The other half of the rear axle clutch pack ...

...replace the rear abs speed sensor in a 1998 dodge 1500 its going to be two bolts and mounted on top of the of the rear differential and an electrical conection leading to that sensor. Un bolt it and ...

...rear end is only turning on one wheel. He is needing to fix the other side. Any information will be appreciated. Thanks....Sandy How this works is there are clutches and discs in the differential, ...

...rear wheel speed variations exist, the progressive differential transfers torque to the axle with the better traction, thus minimizing wheel spin and maximizing control. The key to this design is a ...