...generator output voltage for proper battery charging and electrical system operation. The generator F terminal is connected internally to the voltage regulator and externally to the PCM. When the ...
Question about Chevrolet Malibu
...driveshaft send this voltage to the VCM or PCM the computer witch in turn compares the voltages and adjusts main engine controls like fuel trim intake air and the abs system . If you are haveing with ...
...generator pulley (10344). 4. Adjust the drive belt tensioner as outlined in Section 03-05. 5. Install wiring terminal and attaching nut on generator output terminal. 6. Install wiring connector ...
...adjust the generator load on the ammeter slightly above 30A. Limit: max. 0.3V When the generator output is high and the value displayed on the ammeter does not decrease to 30A, set the value to 40A. ...
...an internaly regulated alternator , can output be adjusted regulator is integral to the generator: reg is solid state--no adjustment internal regulator neads to be replaced, or replace the ...
Question about Honda Cars & Trucks
...generator. When started the engine would usually run at a preset speed from the first - this is so the Hz or c/s per second of the output is correct. When an electrical load is applied to the output ...
...generator charges the battery and at the same time it supplies all the electrical loads that are required. The battery is more effectively charged with a higher voltage when the battery is cold and a ...
Question about Ford Cars & Trucks
...generator charges the battery and at the same time supplies power for all of the electrical loads that are required. The battery is more effectively charged with a higher voltage when the battery is ...
...generator charges the battery and at the same time it supplies all the electrical loads that are required. The battery is more effectively charged with a higher voltage when the battery is cold and a ...
...generator. Refer to Section 03-05 . Disconnect electrical harness connector and output terminal wiring. Remove nut and position engine control sensor wiring (12A581) out of the way. Remove the two ...
1,226 questions posted
Usually answered in minutes!
1,306 Questions
1,257 Questions
1,094 Questions
1,067 Questions
997 Questions