...them but cannot get a saw in the area provided. Any suggestions. If he uses a 1/2 inch socket driver, he may be able to snap the heads off the bolts. Otherwise, the bolts will have to be drilled
...2 change head light bulb on a 2000 z24 How do you remove the headlight assemble to change the bulb. I removed the two bolts holding it in but there seems to be another attachment that is not visible ...
...head retaining nuts, then remove the exhaust manifold, seals and gaskets. For the 2.4L engine, remove the front timing chain cover and the chain tensioner. For details, please refer to the procedure ...
Question about Chevrolet Cavalier
2 feet long. A piece of a broom handle would work. VERY carefully check the following--with the car not running, look at the alternator. Note where the belt is located, imagine it spinning. You should
...head bolts: 9....3....1...6...8 O--O--O--O--O O--O--O--O--O 7....5...2...4...10 <--- Front To tighten follow the above sequence in Five Steps: 1. 22 lbs/ft 2. 59 lbs/ft 3. loose all bolts ...
Question about Chevrolet Cavalier
2.0 cylinder head. i've tried pretty much everything even heat. Do you have a 24" long 1/2" Drive Ratchet Do you have a 1/2" air gun Perhaps try some CRC or Penetrine to soak down the bolt shank for a
Question about Chevrolet Cavalier
...2 bolts holding the rear seat back 04 Chrysler Sebring Convertible. Trying to get to the pump for convertible top. Removed back seat bottom. Located the two bolts to remove the rear seat back rest. ...
...head bolts. Break them loose with a 1/2" breaker bar and remove them starting form the outside and working in a circle towards the center bolts. Be careful when you raise the head form the cylinder ...
...head near the mirror. Under pull handles there are 3 philips on the drivers and 2 philips on the passengers sides. Pull the panels from the bottom and lift the panels up. There are 2 black rubber ...
...chances are the head is stuck to the gasket/block. The head will normally sit upon 2 dowel pins which will also,hold it secure. Use a prybar and gently apply force to the head. It will come ...
1,464 questions posted
Usually answered in minutes!
1,849 Questions
1,641 Questions
1,529 Questions
1,438 Questions
1,339 Questions