...light. If none, then follow back to relay. If none there, then try jumping at the relay, just for testing. If that works, then it could be safety cutout system. Some vehicles use an inertial switch, ...
...came back on, replaced the spark plugs, and the light came back on again. Before I replace the wires, is there anything else that could be causing the light to come on due to a misfire. Fuel ...
Question about Chevrolet Cars & Trucks
...light Started up and c-hair of fuel and it died 3 times now no start smell fuel and quit yellow spark Have replaced cap rotor plugs wires EGR coil ECM Rebuilt carb It sounds more like a fuel problem ...
Question about Chevrolet C1500
...back on the code is likely to help you diagnose the problem. 1. If you have a code reader for your car plug it in and it should tell you what the computer thinks the problem is. Remember for the ...
...Light came on and I took back, same problem. They sent it to Chrysller who had it for a month, got back and had no temperature and the anifreeze was where I couldn't see it. Returned car to Chevy, ...
replace the switch, there are locks, tilt mechanisms, air bags, column bearings, etc involved. Failures risk loss of vehicle control (locking or binding for example.).. Hope this gets you going in the
...back. Any secrets? You will need to access the rear plgs from under the van. jack her up and use 2 jackstands and a light. Its a pain , but you can do it! Quinn No secrets, now you know whay it costs ...
...back. They ran a scan of the Engine light and it said Cylinder #4 not firing.The Mechanic said a wire leading to the #4 Injector came loose when they were working on it. He pushed it back in and it ...
Question about Chevrolet Cars & Trucks
...light doesn't test? My 2002 chevy S10ls 4 door 4x4 4.3l started out with a intake manifold leak, mechanic changed Gasket. After this I got a p0302 code so he replaced spark plugs, wires dist. cap ...
...replace but make sure that you don't loose the seal ring and be careful not to cross thread it when putting it back. The adjustment screws for idle mixture were often capped. Likely by now they ...
561 questions posted
Usually answered in minutes!
584 Questions
420 Questions
331 Questions
284 Questions
284 Questions