1993 Oldsmobile Silhouette "remove starter" Questions

...You need to disconnect the battery then remove the plastic cover over the flywheel end of the starter. Then remove the wires and the 2 bolts from the starter. Install is the reverse of the ...

...starter from the top side, and impossible to lift and remove it through the small access opening. You will need to lift your van front end to access the starter and replace it. Just remember to ...

Car will not turn over click only. Lights work. Car will not turn over click only. Lights work. i would have the starter look at,,take it out SOUND LIKE FAULTY STARTER SOLENOID AND STARTER. BUT MAKE ...

...remove the bolts that go straight up. Wiggle the starter out and down and then disconnect the two wires. I hope I've helped. If so please rate my assistance and leave a comment to help others in a ...

...is on the starter....hope this is your reference. a new starter wasn't awfully expensive...but it was a mother bear to remove and replace.....about a hundred bucks or so...in

...the gear teeth on the starter with the teeth on the flywheel...you may be able to obtain just the solenoid by itself ifthis is the case...bad thing is you will still need to remove the

...starter should be down low on the front of vehicle. Take negative battery cable loose. Safely raise and support the front of vehicle. There are safety issues with working under a vehicle, safety is ...

...starter_replace . If you get stuck, please get back to me. Exact procedure from autozone.com is pasted below. Remove or disconnect the following: Negative battery cable Radiator air baffle, for ...

remove the starter prior to old pan removal? But...I have read in a couple forums that the engine must be raised and or engine mounts removed to change the oil pan gasket? Is this correct? From what I

...check wiring from solenoid to ignition switch. if that doesn't work, remove the starter and check them out side the car or have them checked from a specialist. if wracked, replace the starter