...tighten the window on my 87 cutlass supreme 2dr. when the door is open window can be shaken back and forth replace all the felt liners on the window track ,and the inner ,outer seals at the top of ...
Question about Cars & Trucks
...it down as you lower the window. slide it back into place. send it back up holding the glass in place, Not all the way up just enough to reach the bolts. Tighten it up. and mount your door back
...back and forth to release the window regulator handle clip. Remove the three cover caps and front door trim panel screws. Remove the one front door trim panel capped screws from the door pull handle. ...
...pull window back up and wedge it.install regulator and bolt it up to door,move regulator with switch to line up bolts to attach glass, now lower glass onto regulator arms and tighten, hope this
Question about Oldsmobile Cutlass Supreme
the frame and tighten the screws (not too tight) the glass will brake. Tape and paper the new glass for protection and then re-install the same way it came out. Put the rest of the parts back together
Question about Oldsmobile Cutlass Supreme
...back towards the door jam and help it up, what could be the problem remove the door trim and adjust the window channel to hold the glass square . there will be screw adjustments at the bottom of the ...
...back in place, adjust the widow for level and frame fit before tightening all the bolts, once fitted tighten, replace plastic sheet, wiring harness, terst window at this point, to check all fits. If ...
Question about Oldsmobile Cutlass Supreme
...tighten them when you put the glass back in..that said the panelless door will have a plastic or foam "skin" on it carefuly peel it back ( i use a box cutter blade to cut the sticky stuff if it ...
...into are usually slots. You need to loosen them, raise the window all the way, to make sure it is in the right position, jiggle the window back and forth at bit, and then tighten them back down
...till you see the 2 torx screws that "pinch " the window clips loosen them and lower glass into clips till it bottoms out then tighten the clips, test, put back together< use lock tight on torx ...
160 questions posted
Usually answered in minutes!
697 Questions
571 Questions
488 Questions
387 Questions
236 Questions