...the road?? oil, coolant, and transmission fluid levels. make sure that the brake fluid is in good order also. check tire pressure. power steering fluid. drive it slowly at first and than drive ...
Question about Dodge Viper
...put it back in and it started and ran just fine. Had the alternator checked a couple of months ago and it was ok. Is it a power drain or damaged crank sensor? try checking the secondary ground wire ...
power locks all went out. I tried put in new fuses and still nothing is coming on. I hit the lock button on my remote and sounds like doors want to lock and horn beeps. All other lights, windows work.
...power windows or stereo are not working properly. Check and adjust the alternator drive belt. Make sure that it is in good condition. Check battery terminals are shiny clean and tight. Have a load ...
Question about Dodge Viper
...put a new fuel pump on it HelloThe engine and transmission in this cars drive train are fully electronically controlled by a computer called the PCM (Power Train Control Module). Whenever a problem ...
...power & needs to be replace? Starter solenoid. I don't have the page here but in chiltons a page shows the ignition to fuse to relay to starter and if you look closely it's quite basic. I had same ...
...put it back in and it started and ran just fine. Had the alternator checked a couple of months ago and it was ok. Is it a power drain or damaged crank sensor? i would rule out the crank sensor. i ...
put the new one in because its real compact Hi there:Check this procedure on 2.5L (VIN N) Engine...Disconnect the negative battery cable.Remove the right side under cover.Remove the speed control
but you won't lose power while driving like it did before the reset. Dealership will only charge a nominal fee to put the ecm on, my old one was worn and looked like it had burn marks on it
13 questions posted
Usually answered in minutes!
27 Questions
18 Questions
10 Questions
10 Questions
6 Questions