fuel pressure, I gave up and to it to the garage my brother uses. Guess what, it was water in the distributor that causes corrosion to build up and gives a hard to start no start condition even though
Question about Chevrolet S 10
...fuel filter in a 91 Chrysler New Yorker Fifth Edition where is the fuel filter located and how do I change it Fuel filter is under vehicle in front of l/r tire along frame rain. Need line ...
...fuel filter has a splash guard covering it. Remove the two bolts and un-fasten the quick-connects on either side of the filter. Save the two clips unless the new filter came with new ones. Remove the ...
Question about Cars & Trucks
...valve may be carbonizing up --remove and clean --possible throttle body needs cleaning --check exhaust pressure cat converter possible clogging --check fuel pressure --filter clogging or pump ...
...fuel lines, loosen the mounting bracket and remove the filter. 6 Install the new filter but do not tighten the mounting bracket yet. 7 Make sure all fittings and sealing surfaces are clean. Install ...
...fuel filter, lines blown out. The throttle body was cleaned and rebuilt. I presently have good fuel pressure to throttle body. I can start the car with starting fuild and it will run for a couple of ...
...remove the fuel pump. The fuel pump is NOT repairable. It must be replaced as a complete unit. Always use a new gasket when installing the pump and make certain that the gasket surfaces are clean. To ...
Question about Chevrolet S 10
...remove the sender unit in the tank and check the fuel gauze filter on the bottom ,if this is not the cause then check the fuel line pressure on the injector bar ,on this is a tyre vale looking thing ...
Question about Chevrolet S 10
...fuel filter, air filter, plugs, wires and coil packs. car will not go faster than 40-60 and is supper sluggish. hooked the volt meter to it and got the following; 02 sensor, air flow sensor, intake ...
...fuel pump fuse. remove it and start the car. run it until it stops. have a pan ready to catch the fuel that will leak out. there shouldn't be more the a 1/2 pint. when the job is complete, energize ...
689 questions posted
Usually answered in minutes!
1,473 Questions
904 Questions
790 Questions
747 Questions
686 Questions