2002 Chevrolet S-10 "fuel pressure s10" Questions

...fuel pressure while driving. I have changed the fuel pump and fuel filter and fuel pump relay, regulator,and the oil sending unit. Chevrolet S-10 Questions - Fuel System Loses Pressure ... ...

...fuel pressure..has fuel at injectors..fuel pump works..has good oil pressure..runs when gas is poured in the tb..changed ecm..noid tested..just has no power to injectors 1986 chevy s10 2.5l no gas ...

...Fuel pressure regulator?Oil pressure switch?/. Crank sensor? Or no power to injector pump? PERPLEXED!!!! I'd use a gage and check proper fuel pressure, key on engine off, 60--66 psi with spider fuel ...

Fuel Pressure Regulator Where is the fuel pressure regulator located on a 1999 S10 chevy pick-up?? not sure on an s10 but it should be close to the same position as a full size truck. Should be in the

...fuel pressure switch, oil pressure switch, o2 sensor, map sensor, distrib cap, rotor, electric part on dustrib, check for 12v to fuel injector good, check ground good, fuses good, ecm swapped changed ...

fine,idles fine,but driving down the road it seems to misfire. Sometimes it runs just fine. I replaced fuel filter,plugs,cap,and wires but no change. Check fuel pressure,fuel pump maybe on the way out

...CYLINDER, SOUNDS LIKE IT IS FLOODED. IT IS THROTTLE BODY . IT TURNS OVER BUT DOES NOT FIRE. first you need to check if your are getting spark, then go to fuel pressure, you should have 60lb of ...

...one from 1985 S10 blazer? no, they are different pressure. it has to come from one with central fuel injection, like maybe 94 and up. also, the sending units even then 1999-2005: 4 door models

...fuel pressure check exactly on a 92 chevy s10 4.3litre fuel injection tbi c/k ,? Look under the truck and find the gas line coming out of the fuel tank and follow the line until you come to the fuel ...

...fuel pressure regulator? I had it on jacks for a couple of days while replacing rear end. When I took it off the jacks, it will not start now. A couple days later it started right up and worked fine ...