...removing the drive shaft from the gear box of my 02 front wheel drive impala. Any suggestions? The easiest way is to rent an inner axle shaft removal tool. You should be able to from a local parts ...
...axle shaft and knock it in 8. back side 3 10mm bolts unbolt 9. front side have to pry off bearing hub Assembly only beacuse has dirt in knuckle hole. 10. clean hub knuckle and reinstall. Its really ...
Front Wheel Hub 205-D070 (D93P-1175-B) or equivalent Remover, Halfshaft 205-502 Removal and Installation NOTE: This procedure applies to both rear halfshaft assemblies. CAUTION: Do not loosen the rear
...removing the front axle wheel end nut. CAUTION: The front axle wheel end nut is a torque prevailing design nut. Do not reuse it. Remove the nut and washer. Remove the steel rod in the brake disc. ...
...front axle. Securely strap the jack to the axle. Remove the upper front axle carrier mounting bushing bolt. Remove the axle shaft housing carrier bushing bolt. NOTE: Front driveshaft removed for ...
...front of the engine. Raise the vehicle. Remove the bolt. CAUTION: The sharp edges on the converter can cut the CV joint boot. Make sure to protect the half-shaft boot with a suitable covering before ...
...front wheelwell, next to the axle. It is a 8mm or 10mm bolt holding the sensor in. Good luck. Turbine Shaft Speed (TSS) SensorRemoval and Installation Disconnect battery ground cable (14301) and ...
2,162 questions posted
Usually answered in minutes!
2,177 Questions
1,746 Questions
1,400 Questions
1,452 Questions
1,181 Questions