ok i have a cam sencer problen have replace sencer and magnet it still cuts the car off and showes the same code Try replacing the "Crank Shaft Position Sensor" this two sensors "Cam" and "Crank" ...
had a crank sencer code replaced it still wont rev over 2,000 rpms same code still comes up after i clear it crank sencer cade What fault code find there?
1999 eclipse no spark checked crank sencer cam sencer changed computer started and ran for a little bit left that morning went to start it and started for a cuple sec and died tryed to start it again ...
NO SPARK .i CHANGED CAP',ROTOR, SENCER AND CRANK SENCER is 12v getting to the ignition coil,,is low tension side of coil shorting to earth,so killing the voltage build up in the coil,
my 1998 Buick Park Avenue is miss fireing for some reason i chaged plugs,crank sencer,idle control and most other sencers on this car plz help im stuck!!! change plug wires have injectors tested fuel ...
Question about Buick Riviera
why No pulse to fuel injecter has new crank sencer new cam sencer? injector, sensor. spelling lesson over.
I have a 98 s10 v6 vortek. Is geting gas has new coil checked icm sencer and relays won't even start with carb spray have good spark could this be a crank sencer Not if you got spark & injector ...
Vehicle stalled wouldn' code P1391 P1391 is a timing referance code, your timing is crucial to engine operation, this can be caused by the crank and or cam position sencer. If you changed these and ...
Chyrsler 2003 300 M. Engine light has been one. Put new crank sensor and cam sensor on. Engine light still on. Replaced timing belt and light is back on the first day after. Help! try the o2 sencers ...
v belt broke rapped around crank pully broke sencer wont crank The crank balancer pulley needs to be removed so the crank sensor can be replaced. You will need an air impact wrench to remove the ...
97 questions posted
Usually answered in minutes!
621 Questions
245 Questions
219 Questions
125 Questions
112 Questions