Question about Oldsmobile Cutlass Ciera
...oil seeping out.Check out pic.I hope this could be of some help... my 89 cutlass did the same thing....She would bog down ( when the service engine light came on)....Light would go off and she would ...
...oil pressure gauge only goes up to 1 bar, but when I first turn it on it goes up to 3 or 4 until it warms up, then it goes down to zero. Just bought the car and the guy has 5w-30 oil in it. Any ...
...oil pressure then dying. I just changed the oil and the levels are fine. Not sure where to start... any ideas? if this just started when you changed the oil and filter,then it might be the filter,it ...
...pressure REGULATOR. 1: O2, see exhaust manifold ,remove o2 sensor with special tool. 2: put new one in its place and plug it in. done. if tight use heat or penetrating oil spray. 3: FPREG. see ...
Question about Oldsmobile Cutlass Ciera
...oil pressure or too thick of oil causing it not to get pumped up fast enough.. should take a matter of seconds..I have an 89 ford that clatters like a diesel before it runs quietly..it has nearly ...
Question about Oldsmobile Cutlass Ciera
...oil pressure sending unit (which i was told controls gas after vehicle is running) fuel filter, computer, fuel pump relay, I am at a loss now! Hope this helps and hope someone can help me! try ...
...pressure up to the fuel rail. i dont know what else it could be maybe electrical problems? thanks i think you have the rong elecricale cords or batterys or its oil mcdevito75 here, you could have a ...
Question about Oldsmobile Cutlass Ciera
...oil change. Using 89 octane gas. The only way i can drive it is if I very slowly accelerate. If I try to accelerate too fast, it hesitates and slows down until I release the gas and apply it slowly ...
...oil pressure switch and plug, cleaned the egr valve and replaced some vacume lines. Now if I reset the computer (by unhooking the battery for a few minutes) it runs perfect for about 3-5 minutes and ...
...changing the oil. what are your thoughts on the matter? Actually the rear main bearings are known to be noisey. For a long time ford could not use a knock sensor because the engine had so many to ...
472 questions posted
Usually answered in minutes!
575 Questions
540 Questions
492 Questions
476 Questions
412 Questions