1999 Oldsmobile 88 "rocker arm getting oil" Questions

...getting to top of head Have you used an accurate oil pressure gauge to see what you have? If the pressure is so low it is not lubing rocker arms, the main bearings are probably shot. You could try ...

rocker arm (or the cam follower or the cam itself on overhead cam engines) when the piston is at top dead center (valve fully closed). Refer to a manual for the specified lash and adjustment procedure

...rocker arm where the push rod makes contact or does the rocker arm get lubricated thru the hollow rocker arm shaft. Have replaced the rocker arms and the shaft twice because I always have problems ...

...rocker arm a little loose i have two lest rocker arms getting loose after i redid the seal on the right side oil had a little water in it from rain that day and i didnt know all ready did oil change ...

...rocker arm not getting any oil i have a 1983 Ford Mustang with a 5.0 Liter engine. One of the rocker arms is not getting any oil. Does anyone know what the problem could be? 5.0L engines oil the ...

...rocker arm you will have to remove you valve cover to get to the rocker arm. the valve cover is where you put oil in. you can take off the oil cap and look inside with a flashlight, you will see ...

rocker arm ticks I dont know if the rocker arm is cracked or broken or waht, but if I put a thicker oil in it would that raise the lifters, or should I get a new rocker arm? before trying too much the

...Have oil I. Spark plug wells, will remove crank case and replace o rings don't won't to bend valves when putting rocker arm back on Get the crank and cam timing set before you put the rocker arms

...rocker arm valve systems, the procedure I'm familiar with is to remove a rocker arm cover, and (one at a time!) while the engine is running, slowly back off the rocker arm retainer nut or bolt just ...

...getting a tapping/ticking sound at cold start. Brand new lifters rocker arms are not new. Here are 3 causes for lifter tick! Bad Lifter, Dirty Oil Deposits, Bent Push Rod, The rocker arms will make a ...