1992 Oldsmobile 88 "install new blower motor" Questions

Ad

new blower installed I just had a newe blower installed and there still isn't anything blowing from the vents, hot or cold. I'm not sure if its a fuse problem or not, the heat display doesn't light up

Ad

...install, then disconnect wire connector pigtail, pulling the first three relays may give better access to the pigtails and connector locks, Then jumper power to the two blower power wires to verify ...

Ad

...install a new hub clamp. Install a new motor mounting seal on the blower housing before installing the blower motor. Position the blower motor and wheel assembly in the blower housing and install the ...

...new seal, position the heater blower motor and blower motor wheel assembly to the heater blower motor housing with the flat side of the flange near the heater blower motor switch resistor (18591). ...

...install a new heater blower motor 2000 Saturn Removal & Installation Select the following settings: Turn the ignition ON Select Recirc in the OFF setting Turn the ignition OFF Disconnect the ...

...install a new blower motor on 1999 chevy silverado 1 Disconnect the electrical connector from the blower resistor 2 Remove the blower motor insulating cover screws. 3 Disconnect the electrical ...

...new blower motor at Auto Zone and they will have the step by step instructions you for you get the job done. To Remove: Remove the instrument panel sound insulator panel (if equipped). Disconnect the ...

...does this job, they will jack up the engine/transaxle to make room. The motor itself is not cheap either, a replacement Delco is well over $200. I will let you know if my new motor install

...new blower motor- Disconnect the negative battery cable. Disconnect the blower motor lead connector from the wiring harness connector. Remove the blower motor cooling tube from the blower motor. ...

Question about Oldsmobile 88

1 Answer

...Install the new blower motor with heat shield. Refer to Steps 4 and 5 in the Instruction Sheet, P/N 52494110, found in the blower motor kit.3. Install the blower motor retaining screws.TightenTighten ...

Not finding what you are looking for?
Cars & Trucks Logo

260 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Oldsmobile Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...