...SENSOR LOCATION FOR 1992 OLDS CUTLASS CIERA That year Ciera came with two diiferent engines. if you have the 2.5 liter engine it is located under the hood, center, rear engine area, below ingnition ...
...could be a crankshaft position sensor located on the back side of the engine. There is a two wire plug on it and should be close to the freeze-out plugs. you will need an 8mm wrench to remove
Question about Oldsmobile Regency
...crankshaft sensor on 1992 Olds 88 I have a couple of questions regarding this job. First of all is the balancer bolt left handed or right threads? I have seen both in discussions. Secondly, is the ...
...sensor on a 1988 olds. 2.8 v6 should be behind the bottom pulley(harmonic balancer)(crankshaft pulley).You will have to remove the bolt in the pulley first,to do this.You will have to remove the ...
...crankshaft sensor problem. was not able to start until engine cooled down.... It almost sounds like your car is vapor locking, but with the information given it could be a lot of things. will not ...
...crankshaft sins or are all new and still have the same issue runs fine then all of the sudden it just shuts off for no reason no lights nothing also have replaced the computer any ideas on what I am ...
...crankshaft angle sensor, camshaft angle sensor, ignition coil, ignition module, knock sensor and PCM (powertrain control module). The engine relies on the ignition spark to be delivered to the ...
Question about Oldsmobile Regency
...crankshaft sensor is bad it has 2 the engine has a 24X and a 3X sensor which should be changed 24X behind harmonic balancer or otherone Your ckp sensor is in the engine block in the back just above ...
88 questions posted
Usually answered in minutes!
97 Questions
60 Questions
146 Questions
103 Questions
72 Questions