2005 Chevrolet Cobalt "connector rod" Questions

rod and connector to the door mechanism. Sometimes these plastic connectors become disconnected, but most of the time they break. The L portion of the rod goes through the hole of the connector. There

rod and connector to the door mechanism. Sometimes these plastic connectors become disconnected, but most of the time they break. The L portion of the rod goes through the hole of the connector. There

...ends and they will sometimes come off, but usually they will break. You probably have rods and the connectors will need replaced. You can take your door panel off and actually see the connector

...rod (22152) from the handle link connector. Remove one nut and screw. Remove handle and pads from door. ---------------------- Some rods are double 90 degree rods, they require the handle or lach to ...

Connector Rod bearing replacement I need to know how to replace the main and connector rod bearings in a 1996 Chevy S-10 To do that properly you will have to pull the motor out, remove crank, check to

...rod . If connector is melted obtain a pigtail connector and cut and solder a new connector in and install switch in reverse order ! Note that useing diaelectric grease in connector to switch helps ...

...connector you will notice one side is open. You just push that and once it is unsnapped from the rod, the rod comes out. If you need any further info please leave a comment and I will be glad to

...a picture of a typical "swing away" connector so you can see how it unsnaps from the rod. I think yours will be green and blue, so remember which is which, one goes on the right and one on the ...

actuator, it should have a rod connecting attached to the lock cylinder, also there should be an electrical connector. Disconnect the rod and the electrical connector and remove actuator from the door

...HANDLE TO ACTUALLY GET THE DOOR TO RELEASE. 75 chevelle malibu 2 dr coupe. its a connecting rod, held in place by a small plastic cup-connector, sounds like the rod has come out of the connector ...