Question about Chevrolet Suburban 2500
...oil pressure light came on once. I took ito to a machanic but he couldn't find anything wrond with it. Whats causing this problem? I had the same problem with mine. I installed a fuel pressure gauge, ...
Question about Cars & Trucks
...oil pressure gauge rev up when I rev the motor in park. I just changed spark plugs and wires and I installed a cai and removed and installed the original air filter system and just noticed oil ...
Question about Cars & Trucks
...install a after market oil pressure gauge on a 2000 Chevy suburban with a 5.3L . find the electric pressure sender unit in the side of the block, unscrew it and install a "T" piece screw the electric ...
Question about Chevrolet Suburban 2500
...install manual oil pressure gauge on 2006 chevy 2500 with 6.0L Vortex where the oil pressure sender unit is on the block install a "t" fitting . Place the electrical unit in one side and a brass ...
Question about Chevrolet Suburban 2500
...oil pressure! 2006 chevy silveado 2500hd 6.ol crew cab 92,000 miles engine noise @ and above 2500rpm kinda like a clanking/rattle on the right side of block.Trans failed and replaced. 95,000miles no ...
...oil pressure switch, remove it, install a gauge and test. In some cases ( GM/Chevy ) the oil switch also has some control over the fuel pump. So jumping the relay to allow the engine to run might be ...
...No its not common. Why do you think it quit? Remove the oil pressure sending unit and install a hand held mechanical gauge and check for pressure. If the pressure is good you have a bad sending
...oil pressure oil pressure up to 40 psi on start up but after warmed up drops to 10 or below psi oil light wil come on when at stop light I too oil pan off yesterday and installed a High volume oil ...
...oil sinding unit and install a manuel gauge and see just what the oil pressure is if below 10 psi at hot idle replace the bearings and oil pump in the engine. if this is a chevy 350 make sure you ...
Question about Cars & Trucks
...distributor. To install: Coat the first two or three threads with sealer. Install the sensor and tighten until snug. Engage the electrical lead. Connect the battery cable and fill the engine with
130 questions posted
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions